Able to cut without Torch Touch signal, by manual zeroing z-axis?


Hello, i want to cut plasma without the Torch Touch signal.

I like to set the z-zero point manual by jogging down with the z-axis and then zero it out.

I use a Proma THC150 for the height control.

And another one: do you usually use the z-home switch on a plasma machine?


MASSO Support
Staff member
Simply don't include the probing cycle G38.2 in your files and automatic touch will be disabled.

For the Z homing it really depends on your setup and requirments, some people use it and some don't.