Controlling servo motor with Masso software.

[sun788]

How to control this 110st-m06030 AC servo drive with Masso software?

After I switched them on, I can still turn the servo motor shaft by hand!

Base on Masso's suggestions, the servo drive should be wired to the controller as follows:

1. MASSO Axis S+ to Drive's PP+
   
2. MASSO Axis S- to Drive's PP-
   
3. MASSO Axis D+ to Drive's PD+
   
4. MASSO Axis D- to Drive's PD-
   

Your help will be great to me!

 

[masso-support]

If the motor shaft is still free to be rotated by hand after power up then you need to wire your drive's enable signal via the E-Stop button.