DIG3D.Fix

[adamfenn28]

Would the DIG3D.Fix wire up essentially the same as the probe in this post: https://forums.masso.com.au/threads/dig3d-lp-m.3183/#post-23475

For reference, here's the diagram from their documetation:

 

[cncnutz]

The DIG3D.Flx probe is a member of the DIG3D touch probe family.
This touch off can be order with either N.O or N.C with either NPN or PNP output
Wiring to MASSO will depending on which one you order.
Wiring for both versions are shown below.
Invert the Probe input logic as needed to show Low when the probe is idle and High when Triggered
Cheers Peter



PNP Version








NPN Version