Freezes with mdi input or cycle start on a g code file

T

thomasvank

Thomasvank
Hello, I just purchased a masso g3. I have everything hooked up and jogging X,Y,Z,A limit switches work and it homes perfectly spindle runs in both directions. When I put say G0 X0 Y0 into the mdi and hit enter the controller freezes and doesn't move and ESC press does nothing. the only thing is to power cycle the controller. The same happens with any file I load and try to start cycle. Freezes. my controller sn is G3-6127. Is the software build bugged?
 
T

thomasvank

Thomasvank
Thank you for the quick response! :) I have not put values into the b axis yet. I don't plan on needing a b axis for he time being but thought it would be better to buy the controller with more functions then I need just in case I need them in the future. I will try some dummy values tonight. I really wish there was a check box to disable the A and B axis when not in use. As not all mills use an A and B axis all the time, for example if you removed a rotary table to set up a 3 axis job.

Thanks Again! and I will let you know the out come.
 
T

thomasvank

Thomasvank
It worked! I ran a quick part a soft jaw I had ready to go and aside from setting my origin off do to forgetting the stock offset everything ran great. thanks again for the help :)
 
You must log in or register to reply here.
Top