Fuling DZB 200/300

[Frets4Vets]

in over my head on inverters. Any wiring diagrams for Fuling DZB280? nothing directly found online, but have manual for 200/300 series

 

[breezy]

Use the following as a example. They are basically the same.

Yuhuan Huanyang

docs.masso.com.au

Definitely follow the steps laid out in the video, short cuts will lead to headache trying to solve problems.

Spindle VFD examples

docs.masso.com.au

 

[Frets4Vets]

Thanks!

 

[cncnutz]

​

Caution: Before any VFD can be used it must first be configured correctly to work with your spindle.
Incorrect spindle configuration can lead to damage of the Spindle, the VFD or both.
This diagram is based on the default configuration shown in the VFD documentation.
Please be aware that changes made to configuration and link on the main board may make this drawing incorrect.

 

[Frets4Vets]

Awesome, thanks!

 

[newbie]

I am installing a fuling vfd . The spindle will not start. The 0-10v works [display changes}, But the off on does not. Checked voltage on pin 6 to grd with spindle on and off voltage does not change 25v Would problem be in Masso or vfd Tks in advance

 

[cncnutz]

Why are you measuring Spindle control pin 6 to GND.
That should be connected to DCM of the spindle and should be islolated from MASSO GND.

Did you follow the step by step VFD install guide?

Spindle VFD examples

docs.masso.com.au

DId you follow the step by step trouble shooting guide?

VFD and Spindle Testing

docs.masso.com.au

Regards Peter

 

[newbie]

A little history I had a hunyang vfd it snapped and popped and let the smoke out. So I hooked up the fuling acording to Plan and this thread. Set the 14 parameter as per instructions I tested voltage at vfd leads with no change with spindel off or on, Thinking blew isocoupler 0-10 volt works fine

 

[cncnutz]

Does the troubleshooting indicate that the opto is faulty? If so you can use a spare opto to or even grab the reverse one to get up and going.
Cheers Peter

 

[newbie]

Good Morning {here at least] I seem to have lost 0-10v. Getting reading of .06 v at pin, plug out . spindle @ 50% and at 100% the same

 

[cncnutz]

Did you specify a spindle speed either in MDI or by entering a speed in the F2 screen?
Cheers Peter

 

[newbie]

I thank you for your help The problem was I lost circuit pin 5 to ecm

 

[newbie]

Sorry ecm to pin 4

 

[Hektoen|]

ave lost 0-10v. Getting r

View attachment 6164​

Caution: Before any VFD can be used it must first be configured correctly to work with your spindle.
Incorrect spindle configuration can lead to damage of the Spindle, the VFD or both.
This diagram is based on the default configuration shown in the VFD documentation.
Please be aware that changes made to configuration and link on the main board may make this drawing incorrect.



View attachment 6163

Thanks for the Help, Maybe stupid Question, But why are some lines Dotted ?

 

[breezy]

Maybe stupid Question, But why are some lines Dotted ?

Not stupid question,
Just so that the lines can be identified if they cross solid lines, otherwise you could be confused if there is a connection there or not where lines cross.