Fusion 360 and G54 work offset

[hgriffin1]

Anyone using a G54 work offset with Fusion 360 with the Masso post processor? I am not seeing G54 showing up in my Gcode after selecting either 0 or 1 in the post processor setup tab in Fusion 360....

 

[masso-support]

where are you selecting the 0 or 1 option ?

 

[peter35]

Don't know if it is the right way but l use nc editor and change offset there.

 

[masso-support]

anyways even if the gcode does not have G54, still G54 is the default offset load on power up and you dont need to load it.