"G3 controller not talking to servo drive thread" - missing?


Hi Masso,

Can you tell me where this thread has gone?

I was looking to see whats happened with other users to see if their problem has been fixed.

My problem has not been fixed even after you modified the board for me and bridged across the current limiting resistors.

I'm suspecting that my stepper drivers may not respond to the ~3.7V logic output when they are designed around the 5V TTL standard everyone seems to expect.




MASSO Support
Staff member
we have removed that topic as users were damaging the boards trying to remove the resistors.

whats your controller serial number? and whats the drive model?