maciassimon
maciassimon
When a file is finished, and we come back to the origin with an MDI command "G0X0Y0", the file is read and machining starts again!
A big mistake!
A big mistake!
Gcode Relaunch with MDI Command Prompt
- Thread starter maciassimon
- Start date
machinedude
machinedude
do you have a M30 at the end of your program?
maciassimon
maciassimon
Yes !
I think this is a mistake, because a simple move command should not be able to start a machining cycle!
Thanks for the help machinedude !
machinedude
machinedude
if you had not used a M30 then I could see the controller not knowing any better and maybe acting that that way. I could see this being a issue. often after you run your first part you do your checks and if something is off. the first thing to do would be go back and double check your edges.
@maciassimon can you please provide the below and we will have this checked on priority:
- Your controller serial number.
- copy of the gcode file.
- copy of the MASSO settings file as per this link: https://www.masso.com.au/docs/masso...download-machine-profiles/save-load-settings/