Gerber Dimension 200x upgrade

[neon_armadillo]

Has anyone upgraded the electronics on a Gerber Dimension 200 machine? Do I need to buy new drivers & steppers?

 

[breezy]

@neon_armadillo

More details about your drivers required to give you an answer.

Basically if they accept S&D digital signals you are good to go.

And for your spindle, the VFD needs to accept an analog 0-10v speed signal and digital FWD & REV signals.

Regards,

Arie.

 

[neon_armadillo]

I have this unit up @ my local Makerspace, I will get over & take a look this weekend & see if I can identify the drivers. Thanks for the info.

Shannon

 

[massoboy]

I have this unit up @ my local Makerspace, I will get over & take a look this weekend & see if I can identify the drivers. Thanks for the info.

Shannon

I have this unit up @ my local Makerspace, I will get over & take a look this weekend & see if I can identify the drivers. Thanks for the info.

Shannon

Hi Shannon
I have a Dimension 200 that I'm thinking about converting to Masso controller. Just wondering if you were successful in completing your conversion?