Jasic cut 100 L201 to Proma thc 150

[Ross]

Hi, I was wondering if anyone has wired this combination up and if so can they share a picture diagram of the wiring for me!

Not sure if it has a 1:50 divider if so where to find it?

Thank you in advance.

From Ross.

 

[masso-support]

does this plasma have a CNC connector? can you please share a link to the user manual.

 

[Ross]

Not sure cause the manual came in Thai and I speak Ozzie.

I sent an email to Jasic today, just hope to get an English manual emailed to me from them soon.

I did see on a sales leaflet it was suitable for robotics.

It has a 2T 4T switch and a connect to the pilot plug on the front.

Here is a larger photo showing front panel.

Thank you From Ross.

 

[masso-support]

any connectors at the back?

 

[Ross]

No connectors on the back panel.

Thank you from Ross.

 

[masso-support]

In that case you will have to wire a relay to the hand torch to switch plasma on/off.

Also don't think it will have a divider as there is no connector for the output, you might be bale to use the PROMA 150: https://www.masso.com.au/docs/masso...a-torch-height-control/proma-compact-thc-150/

 

[Ross]

Ok that will have to be the way I go with it. No divider, just use full voltage terminals.

More searching on the internet before I wire this up!

Thank You for your time from Ross.

Just took this photo to show the build so far. "GETTING CLOSER"

 

[masso-support]

looking good!