Lab 4.02.34b Z retract

[thewatchmker]

During cutting, the z axis failed to retract completely. the z axis showed it retracted completely.

Ran the program twice and happened in 2 different locations running the same program again after homing. 2 different tools, feeds and speeds.

Jogs normally

 

[breezy]

@thewatchmker

Generally failure of Z to retract fully is caused by lost steps on the up command. Jogging quite often works OK.

Did you confirm that the WCS Z was still correct after the retract failure?

Regards,

Arie.

 

[thewatchmker]

sure enough, was a short.


thanks @breezy