lathe

[bo]

har en likt dreiebenk som er p den siden
https://madmodder.net/index.php?topic=13000.0
xmt-2335-kontroller om skall bruke? P1, P2, P3 kobla til p masso g2 spindelkontroll hvilken pin 1-7 p masso g2

 

[masso-support]

is this for axis or spindle?

 

[bo]

whether i can connect my dc speed controller which is on the lathe to masso

 

[masso-support]

is the DC motor controller used for axis control or for running the spindle?

 

[bo]

has a SIEG xmt-2335 controller about keg can connect it to masso https://www.ausee.com.au/shop/item.aspx?itemid=3792

 

[masso-support]

Hi @bo

Had a look at your link but it only contains a photo and no technical information.

Do you have a manual for your board please?

Cheers

Peter

 

[bo]

I don't know where to connect it to the mass control

 

[breezy]

@masso-support

Peter,

Googled SIEG xmt-2335 and found attached pdf in industryarena.com It's not the same controller that @bo is asking about, but there are plenty of posts about SIEG C3 lathes.

Regards,

Arie.

 

[bo]

has a similar lathe that is on that side

David's Mini Lathe......

David's Mini Lathe......

madmodder.net

xmt-2335 controls if I use? P1, P2, P3 connect on mass g2 spindle control which pin 1-7 on mass g2