whitmensshed
whitmensshed
Do you have a wiring diagram for the Masso sensor their are 4 wires I would normally use bleu, brown and black what is the white wire for?
masso sensors
- Thread starter whitmensshed
- Start date
@whitmensshed
Connections to the Masso sensors are marked on the exterior of the unit. Looking at the photographs it appears that the following are true:
Brown: 9 - 24 V+
Blue: 0V (V-)
Black: Normally Open (NO) i.e. Voltage will appear on this conductor when the unit is activated.
White: Normally Closed (NC) i.e. Voltage will appear on this conductor when the unit is not activated
Hope this helps. Patrick
Connections to the Masso sensors are marked on the exterior of the unit. Looking at the photographs it appears that the following are true:
Brown: 9 - 24 V+
Blue: 0V (V-)
Black: Normally Open (NO) i.e. Voltage will appear on this conductor when the unit is activated.
White: Normally Closed (NC) i.e. Voltage will appear on this conductor when the unit is not activated
Hope this helps. Patrick
the info is on the bottom of this page https://www.masso.com.au/product/masso-homing-sensor/
- BROWN (9~24VDC)
- BLUE (0V)
- BLACK (NO Normally Open)
- WHITE (NC Normally Connected)
whitmensshed
whitmensshed
Thanks everyone it was the white wire I wasn't sure of
Phil
Phil