Dear sirs,
I purchased the new masso touch and was going to use it with a sherline mill.
I was thinking to up grade to teknic servo motors on the mill and the teknic salesman asked what the controller
outputs are and the masso docs say -4 to +4 volt signals and teknic doc say 5 to 24volts dc.
anyone know if teknic servos will work
thanksJohn vitek
I purchased the new masso touch and was going to use it with a sherline mill.
I was thinking to up grade to teknic servo motors on the mill and the teknic salesman asked what the controller
outputs are and the masso docs say -4 to +4 volt signals and teknic doc say 5 to 24volts dc.
anyone know if teknic servos will work
thanksJohn vitek
