Multicam stepper motor driver

[makeitcreative]

Any one able to help with how to wire the factory multicam stepper motor drivers to the masso?

they have 3 control wires white yellow and red

I believe the

white is the direction

yellow is the step

red is +5V

thanks

Robert

 

[ross-n]

@makeitcreative

Hi Robert, did you work out how to connect the drivers? I am assuming you have the AXYZ AXI drivers (attached)? I have just ordered a MASSO and hope to connect these too.

My best guess at the moment is the same as the wiring diagram for connecting the gecko-g340 drivers https://docs.masso.com.au/setup-and-calibration/axis-servo-stepper-examples/gecko-g340

 

[makeitcreative]

Hi Ross

I did get the AXYZ drivers going. mine are similar to the ones in the image above.

the connection is the same as the gecko-g340 drivers.

good luck with it.

Robert