Hi,
having a machine with 2400 mm Y-axis, homing can take some time if the tool is at the "wrong" end of the table.
Would it make sense to have a "Near Home Sensor" where you can rapid until the machine is, say 100 mm's from the home sensor ? And then slow down to not pass the homing sensor.
Best regards
Jan
having a machine with 2400 mm Y-axis, homing can take some time if the tool is at the "wrong" end of the table.
Would it make sense to have a "Near Home Sensor" where you can rapid until the machine is, say 100 mm's from the home sensor ? And then slow down to not pass the homing sensor.
Best regards
Jan