Plasma input ok to move arc ok

[jcoldon]

is there a fix or patch i can use to stop motion when arc ok input is lost during cutting. To stop motion from loss of arc

it seams only arc ok input only used to start movement then that it a loss on input does not stop movement . this is nessary is there a fix for this

 

[cncnutz]

Hi jcoldon

Please check out the Beta version 4.02.34b
To do this you will need to signup for Beta release testing in your my-Workshop portal.

The Beta release has had your requested stop on loss of Arc OK feature added.

On loss of the Arc OK signal MASSO will enter feed hold, the Plasma and THC are turned off.

Hope this helps
Regards Peter

 

[jcoldon]

Thank you peter for that info i will check it out I been working with neuron he now has a masso ttl interface board ready to go and hookup the masso to neuron THC simplicity

so every THC setting needed neuron does in there unit and more.

i just be using the masso y and x axis neuron controlls the z i almost ready to try the setup soon