Plasma router controller

[peter35]

Are there plans to supply a plasma/ router controller?

I have built a 3M x 1.5M table which is setup as plasma cutter and changeover plate for a router. Was setup initially with mach 3 but am trying to run Masso on all my machines, easier for me and staff to use one style of controller.

 

[masso-support]

Yes for sure, there will be a hybrid version of the software as some people have requested this earlier, in this version of the software you will be able to have the router and plasma both controlled together, the hardware will still be the same.

 

[scotg1107]

Quote from MASSO Support on June 12, 2018, 9:21 pm

Yes for sure, there will be a hybrid version of the software as some people have requested this earlier, in this version of the software you will be able to have the router and plasma both controlled together, the hardware will still be the same.

Is this available now? If not any idea on an ETA?



Thanks

Scot