Probing screen now uses work offset instead of temporary offset which I think is a great improvement because the position is always saved.
But I often need a probing routine during machining and there is no G-code to set the work offset relative to the current position.
What I'm looking for is something similar to LinuxCNC G10 L20. Actually I would find this much more usable than the currently available G10 L2.
But I often need a probing routine during machining and there is no G-code to set the work offset relative to the current position.
What I'm looking for is something similar to LinuxCNC G10 L20. Actually I would find this much more usable than the currently available G10 L2.