When I use the Jump to Line, the screen freezes and will not track.

[cncnutz]

Reported by @njesr63

When I use the Jump to Line, the controller starts normally from the line I input. However, the screen freezes and will not track.

 

[cncnutz]

Hi @njesr63

Thanks for the report Nick.
I did some testing and found that MASSO is working as expected on Jump to line so I need more information.

What line number are you jumping too?

MASSO only displays the first 2000 lines of Gcode. It may be 1950 lines I can't remember the exact number anymore.
If the line you are jumping too is higher than 2000 then the file will run but it will not show the lines as it runs.
This is addressed in the new Beta version being worked on which will display all lines as it runs.

Please let me know more information on this and I can look further into it.

Cheers Peter

 

[njesr63]

Peter,
I broke my program up into chunks that are less than 2000 characters. The current piece that I am running has only 292 lines and the active line tracking is still not correct. In the screenshot below, the machine is stopped at a M1 command. As you will see, the M1 command is not on the screen. It is actually two lines below what is highlighted and below the screen as I mentioned above. Also please note that the display is correct in that the highlighted line is 221. The M1 command is line 223.

I have attached the G Code file and a screenshot below.

Thanks,
Nick

 

[cncnutz]

Thank you for the test file.
I have tested and confirmed your observation and created a ticket to get it investigated.
Cheers Peter