Wiring of HSS86 driver and closed loop steppers

[minimillaidan]

Hi Everyone,

I am currently looking into how best to wire my HSS86 drivers and closed loop nema 34 steppers

i have attached pictures of all the wiring documentation I have of the driver and a picture for reference.

i am going to be using 1 motor for each axis X,Y,Z

hows best to wire these drivers to masso in order to get the most out of them?

Thanks Aidan

 

[masso-support]

did you have a look at the MASSO documentation? there are a lot of examples and this one is very similar to your drive: https://docs.masso.com.au/wiring-an...xis-servo-stepper-examples/leadshine-cs-d1008

 

[minimillaidan]

wow thanks for the quick reply

Just looked. Looks very similar I agree! Will give it a go wired up as mentioned in that driver wiring and see how it goes.

Thanks Aidan

 

[am]

hello Aidan. My drives are also hss86. and i need help to connecting them. can you please tell me how you did it.

 

[minimillaidan]

AM,

If you see the link above that masso support attached, i wired them exactly the same as the leadshine-cs-d1008 drivers

Hope this helps

Aidan